More than sensors+automation
Zoeken
JUMO Meet- en
Regeltechniek B.V.

Rijnkade 18
1382 GT Weesp, Nederland

Telefoon: +31 294 49 14 91
Fax: +31 294 41 95 77
E-mail: mail(at)jumo(dot)net

JUMO Wtrans-zender voor draadloze weerstands-temperatuursensoren (90.2930)

Kenmerken

  • voor werktemperaturen van -30...+260°C of -200...+600°C
  • voor mobiele of stationaire temperatuurmetingen
  • reikwijdte zender (ongehinderd) 300m

Klantvoordelen

  • geen bedrading tussen sensor en besturing noodzakelijk door moderne radiotechnologie
  • storingsvrije overdracht van meetsignalen met telegramcodering

Omschrijving

The Wtrans transmitter is used in connection with a Wtrans receiver for stationary or mobile detection of temperatures within the operating range of -30 to +260 °C or -200 to +600 °C. This measured temperature value is transmitted wirelessly to the receiver of the Wtrans measuring system; here it is displayed and available digitally at the RS485 interface as well as an analog output. One receiver variant can signal various alarms on two relay outputs.
The transmission electronics of the RTD temperature probe are placed in the case so that they are vibration-proof; the case is oil-resistant and acid-proof. The ambient temperature of the case may either be from -30 to  +85 °C or from -25 to 125 °C. The protection type is IP67. A durable lithium battery with 3.6 V is used for voltage supply.
The radio frequencies of the Wtrans measuring system (868.4 MHz or 915 MHz) are largely impervious to external interferences and allow transmission even in a rough industrial environment. When using the antenna wall holder with the 3 meter cable for the receiver then the maximum open air range is 300 m. The stainless steel protection tube with the Pt1000 temperature sensor according to DIN EN 60751, class A in a 3-wire circuit is available with a flat, oblique, or centered probe tip. The insertion length is between 30 to 10000 mm. The variants are available with an extension tube or an M12 × 1 plug connection to connect Pt1000 RTD temperature probes.
The Wtrans transmitter is also available as a version with ATEX approval (basic types 902930/15, .../17, .../55). These devices can be installed directly in explosive areas up to zone 0. The receiver is installed outside the Ex zone. The radio data transmission from the Ex area avoids costly installations with cable and protection barrier or supply isolators.
The design of the JUMO RTD temperature probes is to be coordinated when ordering. The Ex variant with M12 connector is always delivered with an approved JUMO RTD temperature probe with PTFE connection cable. Devices with process connections can be ordered in versions with Ex zone separation.
A setup program is available as an accessory for easy configuration and parameterization of the Wtrans measuring system on the PC. The OnlineChart function can be used optionally to record the measured values on the PC.


Take a look how easily the JUMO Wtrans system can be configured.

Documentation
Technische documentatie
Handleiding
Productinformatie
Prospectus
Typeonderzoek
Vakartikel
Basis
Duits Connection diagrams for RTD temperature probes and Thermocouples (94,8 kB) Duits Construction and application of RTD temperature probes (1.768,5 kB) Engels Connection diagrams for RTD temperature probes and Thermocouples (96,4 kB) Engels Construction and application of RTD temperature probes (1.841,1 kB) Frans Connection diagrams for RTD temperature probes and Thermocouples (97,5 kB) Frans Construction and application of RTD temperature probes (1.161,5 kB) Deens Connection diagrams for RTD temperature probes and Thermocouples (86,5 kB) Deens Construction and application of RTD temperature probes (733,2 kB) Slowaaks, Tsjechië Connection diagrams for RTD temperature probes and Thermocouples (515,9 kB) Spaans Connection diagrams for RTD temperature probes and Thermocouples (125,1 kB) Spaans Construction and application of RTD temperature probes (1.672,5 kB) Turks Connection diagrams for RTD temperature probes and Thermocouples (57,1 kB)
Conformiteitsverklaring
Andere
Veiligheidsverklaring
Certifikaat
Software

Please take note of our General Terms and Conditions and Clauses for Paragraph 1.4 General Terms and Conditions.

Artikelnummer Product omschrijving Price of the full version
00488887

JUMO Setup Wtrans

Download 30 dagen testversie (29.3 MB)

additional information...
Prijs aanvragen
Accessories

Accessoire artikelen

Artikelnummer Product omschrijving Prijs/stuk
PC-interface mit omzetter RS232/TTL Prijs aanvragen
PC-interface mit omzetter USB/TTL Prijs aanvragen
Farbringe aus Silikon(weiß/gruen/rot/blau) fuer die optische Senderidentifikation Prijs aanvragen
Wandhouder Wtrans zender B-buis 4mm Prijs aanvragen
Wandhouder Wtrans zender B-buis 4,5mm Prijs aanvragen
SET Wandhalter Wtrans Sender S-Rohr 6mm Prijs aanvragen
Wandhouder Wtrans-zender (D=beschermbuis 12mm) Prijs aanvragen
Stekker 4pol Serie 713 (te beschermen) Prijs aanvragen
902150/30-386-1006-2-6-100-56-2500/315,317 Prijs aanvragen
902150/30-386-1006-2-6-200-56-2500/315,317 Prijs aanvragen
Batterij-set 3,6 V/2100 mAh Lithium neutal Prijs aanvragen
Wtrans-Farbkappenset Sender(PEI)(10 Stueck, grau) Prijs aanvragen
Wtrans-Farbkappenset Sender(PEI)(10 Stueck, braun) Prijs aanvragen
Wtrans-Farbkappenset Sender(PEI)(10 Stueck, gruen) Prijs aanvragen
Wtrans-Farbkappenset Sender(PEI)(10 Stueck, blau) Prijs aanvragen
Set Wtrans Dichtungen 2 x 3 Stueck Prijs aanvragen
Lithium-Batterij 3,6 V, 1,7 Ah (-25...+125°C) Prijs aanvragen
Freischaltung für OnlineChart Prijs aanvragen

Accessoire product data sheets

Artikelnummer Product omschrijving Prijs/stuk

Type: Wtrans-zender T01.G1 Insteek-weerstandsthermometer (omgevingstemperatuur handvat -30...+85°C)

Werktemperatuur in °C: -30..+260°C

Doorsnede beschermbuis D in mm: Ø 4mm

Inbouwlengte EL in mm: 100mm

Vorm insteekpunt: Centrisch, hoek 25°

Sende-/Empfangsfrequenz: ISM-Band 868,4 MHz (Europa)

Procesaansluiting: Zonder procesaansluiting

Prijs aanvragen

Type: Wtrans-zender T01.G2 met M12-stekker voor weerstandsthermometer (omgevingstemperatuur handvat -30...+85°C)

Werktemperatuur in °C: -200..+600°C

Doorsnede beschermbuis D in mm: geen (niet relevant)

Inbouwlengte EL in mm: geen (niet relevant)

Vorm insteekpunt: Zonder beschermbuis

Sende-/Empfangsfrequenz: ISM-Band 868,4 MHz (Europa)

Procesaansluiting: Zonder procesaansluiting

Prijs aanvragen